"Companion" Magazine Bumper for Ruger 10/22
At a Glance:
- Easy to install with no permanent modifications to your magazines or firearm
- Comes with two bumpers
- Adds grip to bottom of rotary magazines for easy magazine seating and removal
These extended magazine bumpers for the Ruger® 10/22® 10-round rotary magazines are a must-have for anyone that knows how tricky removing the magazine can be.
Constructed of highly durable Zytel® and designed to work with standard 10-round Ruger® rotary magazines, the Companion Extended Magazine Bumper will provide years of enjoyable use. Stop struggling to remove the magazine and make gripping it easier with a two-pack of these competition grade magazine bumpers from TANDEMKROSS!
Please note: 10-round rotary magazines sold separately.
Don’t forget, all TANDEMKROSS products are made in the USA and come with a LIFETIME guarantee!
WARNING: This product can expose you to chemicals including cadmium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
157 Reviews
-
10/22 Bumper
Good product. Small screws that I decided to use lok tight to make sue since it seemed easy to strip. Works are at and as advertised.
-
Jury is still out!
Installed two of these extenders on new Ruger 10/22 magazines . Two of the four screws holding the base plate in place never tightened. I was extremely careful not to strip the magazine edges. I purchased slightly larger diameter screws which did tighten into the walls of the Ruger magazine. My concern is if you ever take the magazines apart for cleaning, the screws will probably not tighten again. The entire design of how the base plate attaches to the magazine is poor. The four small screws holding the base plate to the magazine barely cut and grip into the magazine.
-
Companion magazine bumper
These are great, they make it possible to grab and have a firm hold on the magazine no mater the position of the Rifles
-
Extended magazine bumper for Ruger 10/22
Well made. No problem to install. Great improvement of grip on empty mag. A+ to TK in my book.
-
mag bumper 10/22
I think i have 20 of these now, sooo much easier to extract these from the rifle. they seem to hold together quite well. I am only dropping them to the bench, about a foot and a half, not to the ground. Ilike them. Wish they came in colors.
-
No complaints
Easy to install, stays put. Perfect for competition.
-
Only Way to Grab That Magazine!
Works on the 10/22 or Ruger American 22 Mag magazines. Especially with older or arthritic hands or in competitive situations.
-
Companion extended mag bumper for Ruger 10/22
Makes changing mags a breeze.
-
Fits Ruger 10/22 .17 & MAG & American 22WMR 9 round Magazines
Bought these to see if they'd work on my Ruger American 22WMR magazines and they fit fine. SInce they're the same as the 10/22 WMR and .17 MAG mags thought I'd post up so everyone would know for sure! So now I have to buy more of that 10/22 and the rest of my mag units. Just wish they sold in larger quantities.Thanks for them at least TC!
