Tactical Solutions Trail-Lite° Browning Buck Mark Holster

This appears to be a very nice holster. BUT I can tell you for certain it will not fit a Browning Buckmark URX pistol. The sight rail running down the top will not allow the pistol to fit into the holster. I do believe if you have a regular round barrel it would work well.

As I started teaching my 13 year old daughter about competitive shooting, I was concerned that we wouldn't be able to find a holster that would be stiff enough to keep it's shape. This is almost perfect. Looks cool and functions the way I need it to. My only issue is that the belt slots are a little long. My daughter wears a 1.5" webbing style belt and there is still a lot of room above the belt to the top of the holster slot -- enough that when she draws the gun, the entire holster slides up with the gun until it hits the belt. I will probably need to find a thicker belt (for more resistance) or a wider belt (hard to find pants with a 2" belt loop for a teenage girl though). Still, though, I love it and would buy it again.

I recently bought the low ride holster and it’s just what my gun needed. It fits great no adjustment needed. I really like the fit on my gun belt. If you are on the market for a new holster buy one of these...

Received the TacSol Trail-Lite holster for my Buck Mark Contour - fits perfectly. While the retention is a bit tight initially, I have adjusted the grip tension screws on the holster and am storing the pistol in the holster to see how well it loosens up. The shape of the holster allows the Contour to fit with a red-dot installed. Very happy with it. Thanks again TK!

The holster came pre-assembled even thought they sent instructions on how to assembly it. I bought the low-ride holster for a Buck Mark Contour UDX pistol. The holster is very good but sliding the gun into the holster was hard, very hard! I adjusted the retaining screw but it was still a difficult fit. I add a 3/8" flat plumbing washer to the two long screws to expand the opening. This helped spread the holster sides apart making the fit tight but manageable. Tried to do the same to the retaining screw but the washer was to thick and literally squashed the rubber spacer that came with the holster. Adding the two flat washers helped I think for my preference. Also broke the edges of the holster with 400 grit sandpaper. They did a nice job of cutting the holster to shape but didn't like some of the sharpness left on edges of the holster sides. With that done I'm very happy with the holster. One thing is that you shouldn't install a trigger that has a width greater than the trigger guard (as noted in the instructions).