At a Glance:
Textured and flat-faced for better control and feel
100% adjustable for pre- and over-travel
Lightweight, skeletonized design
Ruger® Mark III™
Ruger® Mark III™ 22/45™
Ruger® Mark III™ 22/45™ LITE
Ruger® Mark IV™ 22/45™
Ruger® Mark IV™ 22/45™ LITE
Ruger® Mark IV™ 22/45™ Tactical
The trigger of any firearm is critical and must give the shooter as much control as possible. The sleek, skeletonized, and lightweight design of the TANDEMKROSS “Victory” Trigger for Ruger® Mark III™ and 22/45™ provides a flat, textured face that many shooting pros prefer over a traditional curved trigger.
TANDEMKROSS’s unique design allows the shooter to pull straight back, making it easier for the shooter to tell if they are pulling too far left or right. The flat face also offers more real estate for the user to place their finger lower on the trigger. This increases their finger’s distance from the fulcrum, increasing leverage and decreasing the perceived trigger pull weight. While the actual pull weight technically never changes, having your finger further from the fulcrum or pivot still offers you a mechanical advantage.
Pairing this trigger with TANDEMKROSS’s “Blast Pack” (“Thunder” Hammer, “Lightning” Sear, and “Blast Shield” Magazine Disconnect) gets you an “Ultimate” Trigger Kit and is the best way to get you all the tactile and mechanical advantages of the “Victory” Trigger while also actually decreasing your pistol’s trigger pull weight. Please note, the “Blast Pack” and “Ultimate” Trigger Kit are only available for the Ruger® Mark IV™ and Ruger® Mark IV™ 22/45™ and is not compatible with the Ruger® Mark III™ or Mark III™ 22/45™.
All TANDEMKROSS “Victory” Triggers are textured for a no-slip grip in any condition, at any speed, even while wearing gloves!
The included pre-travel and post-travel screws allow for fine adjustment of trigger travel to create consistent, reliably clean trigger pulls. Amongst your included screws will be two different length pre-travel screws and two different length over-travel screws. You will want the longer pre- and over-travel screws if you are installing this trigger on a Mark IV™ 22/45™ and the shorter screws if installing in a Mark III™ or Mark III™ 22/45™.