Wingman +4 Magazine Bumper for Ruger® LCP® II in .22LR

Honest review, may seem easy to install per video, but it's not. Finally got the springs into the magazines after many, many, many tries without them bending. A real pain in the butt to align spring in mag and then get all 14 rounds in the mag. If you want to get aggravated real quick for four extra rounds in each mag, then knock yourself out. I give the manufacturer and customer service A for great assistance, and a C- for quality and ease of installation of parts.

Installation can seem daunting to some folks new to mag reassembly. I found that using my left index finger to hold each coil instead of my thumb made the install a lot easier - took about a minute for each mag. Now four of my ten LCP II 22LR mags has a bumper. An initial run of 250 rounds of CCI Blazer functioned perfectly (one failure to fire, normal for cheap rimfire)

Total pain in the ass to install. I'm no rookie. Bent first two springs I tried to install before I gave up. My gunsmith also had a hard time but somehow made it happen. You guys need to design a tool! Final product is fine but long. Good length for range or backup mag not as primary concealed carry.

Great addition to my LCPII .22lr pistol. The video was very helpful, and watch before installing, take your time when loading the spring. You do loose the conceal ability to some degree when putting in a pocket of my shorts. Hope they make a 12 round, flat Mag for the LCPII .22lr.

The spring is easy to get down with a pencil, getting the bottom pinky extension on is the real PITA. One magazine holds 14, the other holds 13. The one that holds 13 will hold 14 but the magazine wont seat in the firearm. I had the same problem with the sr22 wingman and had to buy another parties spring and follower to function properly. Also to note, the pinky extension is not as nice as my sr22 wingman. This one seems much cheaper quality.